For reference only, subject to actual

Environmental friendly water-based flux UR2000 Introduction

Unibright's UR2000 is an environmentally friendly water-based flux that does not contain volatile organic solvents. It uses deionized water as the main solvent and does not contain halogens, rosin, or resins. Water-based flux has the advantages of safety, environmental protection, no flash point, and non-combustible.

Enquire now

Sample test

Environmental friendly water-based flux UR2000 Product Features

Free of halogens, rosin, and resins. Water-based flux has the advantages of safety, environmental protection, no flash point, and non combustible. It performs excellently in photovoltaic copper strip and copper wire tin plating, especially for photovoltaic copper strip narrow strip tin plating process, which can meet the requirements of rapid tin plating for photovoltaic solder strips. After preheating, there is no tin explosion phenomenon during the tin plating process. The solid content is low, and there is very little residue in the product and tin slag after plating, which can pass strict environmental testing. The product does not contain VOC components, eliminating the worry of excessive VOC emissions.

Environmental friendly water-based flux UR2000 Applicable process

Unibright UR2000 water-based flux is suitable for dip welding, spray, coating and other methods. Suitable for both lead-containing and lead-free alloy solder.

Apply for product information

Environmental friendly water-based flux UR2000 Application

? Unibright UR2000 water-based soldering flux has characteristics such as low volatility and low odor. In the photovoltaic copper strip tin plating process, open immersion welding is used to reduce the amount of soldering flux used.

? Heming UR2000 water-based soldering flux has characteristics such as low volatility and low odor. In the photovoltaic copper strip tin plating process, open immersion welding is used to reduce the amount of soldering flux used.

? If the flux is poured onto a sponge and then applied or dipped, it is recommended to replace the sponge once a day. Do not keep the sponge too close to the tin furnace or add an insulation board between the sponge and the tin furnace.